Output Configuration Example - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

5.2.1 Output configuration example

After connecting the device, the following steps are necessary to configure the LLB for automatic
mode.
No. Action
Set current output
1
range
Set distance
2
range
Set analog output
3
in case of an error
Configure digital
4
output
Configure SSI
5
Output
6
Save settings
1)
Commands are described in chapter 10 "Command set" as of page 131.
If the communication parameters of the device have been lost, please reset the
configuration to the factory settings (9 "Factory settings" on page 130) using the reset
button (see 8.2 "Reset switch" on page 125). Please note that the ID switch must be reset
manually.
Printed in the Federal Republic of Germany
03/09/2016
Comment
Defines if the current output range
from 0 to 20 mA or from 4 to 20 mA.
Example for device 0:
Set current output range from
4 mA to 20 mA.
Defines minimum distance (D
the maximum distance (D
distance range of the analog output.
Example for device 0:
Set distance range from 0 m to 10 m
Sets the current, which should be
applied in case of an error.
Example for device 0:
Set current to 0 mA in case of an error.
Set the ON and OFF level for the
digital outputs.
Example for device 0:
DO 1: off=2000 mm on=2005 mm
DO 2: off=4000 mm on=4005 mm
Activate SSI output
(RS-422 is deactivated)
Example for device 0:
Set SSI configuration
Set output value in error case to 12345
The changed configuration must be
saved to make it permanent.
Example for device 0:
Save settings for device 0
TR - ELE - BA - DGB - 0021 - 06
s0vm+1<trm>
) and
min
) for the
max
s0v+00000000+00100000<trm>
s0ve+000<trm>
s01+00020000+00020050<trm>
s02+00040000+00040050<trm>
s0SSI+1<trm>
s0SSIe+12345<trm>
s0s<trm>
Command
1)
1)
1)
1)
1)
 TR-Electronic GmbH 2011, All Rights Reserved
Page 103 of 156
1)
1)
1)