Set/Get Error Value On Ssi Output (Snssie); Set/Get Measurement Filter Configuration (Snfi) - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

Command set

10.3.6.2 Set/Get error value on SSI output (sNSSIe)

In case of an error the SSI output will show a value corresponding to this configuration. There can be
a replacement value in a range of 0 to 16777215 (24 bit) or 0 to 8388607 (23 bit), the last valid
distance value or the error code. All values are shown either as binary value or gray coded depending
on configuration.
Command
Return successful
Return Error
Parameters
Configuration parameters must be saved (see 10.3.8 "Save configuration parameters (sNs)" on page 145).
10.3.7 Set/Get measurement filter configuration (
The filter applied to the measurement value can be configured according the following command
Command
Return successful gNfi?<trm>
Return Error
Parameters
For additional information, see chapter 5.6 "Output value filter" on page 112
 TR-Electronic GmbH 2011, All Rights Reserved
Page 144 of 156
Set Command
sNSSIe+xxxxxxxx<trm>
gNSSIe?
<trm>
gN@Ezzz<trm>
Device ID (0..9)
N
24
xxxxxxxx 0...2 -1 / 0...2
-1:
-2:
Error code
zzz
Set Command
sNfi+aa+bb+cc<trm>
gN@Ezzz<trm>
Device ID (0..9)
N
Filter length 0: Filter off
aa
Number of spikes to suppress
bb
(always pairs of min and max value)
maximum number of errors to suppress
cc
Condition: 2 * bb + cc <= 0.4 * aa
Error code
zzz
TR - ELE - BA - DGB - 0021 - 06
Get Command
sNSSIe<trm>
gNSSIe+xxxxxxxx<trm>
gN@Ezzz<trm>
23
-1: Replacement value
In case of an error, the data value will be
replaced by this replacement value.
(depending on the settings, the value
will be converted to gray code):
in case of an error the last distance value
will stay at the output.
in case of an error the error code will be at
the output.
(converted to gray code if configured)
)
sNfi
Get Command
sNfi<trm>
gNfi+aa+bb+cc<trm>
gN@Ezzz<trm>
32: maximum value
Printed in the Federal Republic of Germany
03/09/2016