Analog And Digital Output; External Display - TR-Electronic _LLB500(F)-00601 Benutzerhandbuch

Application examples

4.2 Analog and digital output

Activate the "Stand-alone mode" (5.3.2 on page 106) and the device is ready to use. It starts
measuring after power on and updates the analog and digital output according to the configuration.
See chapter 10.3.4 "Analog output" on page 138 for the configuration commands.
Figure 3: AO and DO connection

4.3 External display

If Display Mode is enabled, the LLB measuring system formats the measured distance as ASCII
string, which is understood by External Displays with a serial interface. Since the LLB measuring
system transfers this formatted string automatically on the serial interface after completing a
measurement. Measurement results can be displayed on an external display without an additional
controller.
Figure 4: External display connection
 TR-Electronic GmbH 2011, All Rights Reserved
Printed in the Federal Republic of Germany
Page 98 of 156 TR - ELE - BA - DGB - 0021 - 06 03/09/2016