Device setup
5.3.2 Stand-alone mode
Before starting the stand-alone mode, output configuration must be done (See 3.2 Output interfaces
on page 9)
5.3.2.1 Auto start configuration
The following steps are necessary to configure the LLB measuring system for stand-alone mode with
auto start.
No.
Action
1
Set auto start
1)
Commands are described in chapter 10 "Command set" as of page 131
If the communication parameters of the device are lost, please reset the configuration to
the factory settings (9 "Factory settings" on page 130) using the reset button (see 8.2
"Reset switch" on page 125). Please note that the ID switch must be reset manually.
TR-Electronic GmbH 2011, All Rights Reserved
Page 106 of 156
Comment
Set the LLB measuring system to the
stand-alone mode with auto start and with
the desired sample rate.
Example for device 0:
Set sample rate to fastest possible speed.
TR - ELE - BA - DGB - 0021 - 06
Command
1)
s0A+0<trm>
Printed in the Federal Republic of Germany
03/09/2016