Basic Tools And Installation Kits - Agilent Technologies ALS Handbuch

Basic Tools and Installation Kits

The GC/MS comes with a few basic tools and consumables depending on the
specific inlet and detector that you ordered. Below is a general list of what
comes with the instrument.
Table 27
Tool or consumable
6850 Series GC
T10 and T20 Torx wrenches
1/4-inch nut driver
FID flow measuring insert
Column cutter, ceramic or diamond
1/8-inch Tee, Swagelok, brass
1/8-inch nuts & ferrules, Swagelok, brass
Inlet septa appropriate for type
Inlet insert or liner
GC/MS
1.5-mm and 2.0-mm hex driver
Tool bag
Q-Tips
Cloths
Gloves
Funnel
Hex key, 5 mm or 8 mm
GC, GC/MS, and ALS Site Preparation Guide
Basic tools
6850 Series GC Site Preparation
Used for
Removing tray. Removing covers to access gas
control modules, traps, and pneumatic
connections.
FID jet replacement.
FID troubleshooting.
Column installation.
Connect gas supplies.
Connect gas supplies.
Inlet seal.
Contains sample during vaporization in inlet.
Source maintenance.
Holding GC and MS tools.
Cleaning source parts.
Keeping surfaces and parts clean.
Reducing contamination on GC and MSD parts.
Changing oil.
Removing oil plug.
63