Canadian Installation; Common Instrument Power Cord Plugs - Agilent Technologies ALS Handbuch

7820 MSD Site Preparation
The three-conductor power line cord, when plugged into a properly grounded
receptacle, grounds the instrument and minimizes shock hazard. A properly
grounded receptacle is one that is connected to a suitable earth ground. Be
sure to verify proper receptacle grounding.
Connect the GC to a dedicated circuit.

Canadian installation

When installing a GC in Canada, make sure your GC's power supply circuit
meets the following additional requirements:
• The circuit breaker for the branch circuit, which is dedicated to the
• The service box branch circuit is marked as a "Dedicated Circuit."

Common instrument power cord plugs

Table 54
Table 54 Power cord terminations
Country
Australia
China
112
instrument, is rated for continuous operation.
below shows common Agilent power cord plugs.
Voltage Amps
240 16
220 15
Cable
length (m) Termination type
2.5 AS 3112
4.5 GB 1002
GC, GC/MS, and ALS Site Preparation Guide
Plug
Termination