Espa SPEEDRIVE V2 Installationsanleitung Seite 45

Adjust the micro-switches (
MASTER
SLAVE 1
SLAVE 2
SLAVE 3
SLAVE 4
SLAVE 5
SLAVE 6
SLAVE 7
Respect the polarity of the RS-485connection:
1 2
A B
7.2) Configuration.
7.2.1) Configuration of the "Master" pump:
The factory configuration is best for most installations.
If you wish to change any of the parameters, go to the auxiliary pumps configuration menu through menu no. 23
(see section 5.3)
7.2.2) Configuration of slave pumps:
units.
7.2.3) Individual configuration of a slave:
necessary, deactivate the transfer to that pump and configure it individually.
In the configuration of this slave:
. . .
figure 6 o figure 7
) as needed:
SWITCH 1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
3 1 2 3
A B
s not activated, you must configure all the parameters on the slave
TRANSFER THE CONFIGURATION TO THE SLAVE SPEEDRIVES
Deactivate the transfer of parameters
SWITCH 2 SWITCH 3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
1 2 3
A B
- 45 -
SWITCH 4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF