Espa SPEEDRIVE V2 Installationsanleitung Seite 38

PARAMETER RESET
CONFIGURATION OF ADVANCED PARAMETERS AND METER RESET
SUBMENU USED TO RESET METERS (password ◄◄◄)
DELAY ON
Delay time between the activation of auxiliary pumps.
Avoid continuous start-ups of reserve pumps due to fluctuations in the
installation.
HYSTERESIS OFF
Difference between the stop frequency of the main pump and each auxiliary
pump.
DELAY HYSTERESIS OFF
Delay time in the stop sequence of auxiliary pumps.
FACTORY PARAMETER
To reset all changes of parameters and return to default settings, click OK.
Confirm the change to default parameters.
Select "Yes" and click OK to return to the default settings.
ADVANCED PARAMETERS
To modify the advanced parameters or reset the meters, press OK.
To complete the setup, click ▼.
ATTENTION. These parameters can only be configured by expert staff.
PASSWORD
There are 2 passwords available, depending on the action:
 ◄◄◄+ OK: to reset all meters.
►►► + OK: to adjust the unit's regulation and operation.

RESET METER
Select "Yes" and click OK to reset all meters.
Confirm RESET METER.
Select "Yes" and click OK to confirm reset all meters.
RESET ALARMS
Select "Yes" and click OK to reset all alarms.
Confirm RESET ALARMS.
Select "Yes" and click OK to confirm reset all alarms.
- 38 -