Espa SPEEDRIVE V2 Installationsanleitung Seite 40

DISPLAY OF THE ALARM LOG
From any screen, tap OK to return to the main screen 2.1
STOP DELAY
Timing before a stop.
MODULE TEMPERATURE
Current temperature of the module or circuit.
MOTOR FREQUENCY
Configured nominal motor frequency. It should match the motor nameplate.
MAXIMUM STATIC HEAD
Configured maximum static head. It should match the pump nameplate.
TRANSDUCER TYPE
Maximum pressure value of the installed transducer. It should match the
transducer nameplate.
DISPLAY ALARMS
Press OK to confirm.
To display the log, press ◄ (Hist)
To display the parameters, press ► (Param)
OVERCURRENT
Number of times an overcurrent is detected.
(see Section 6)
SHORT-CIRCUIT
Number of times a fault caused by a short-circuit is detected.
(see Section 6)
VOLTAGE
Number of times the inverter has stopped due to a voltage fault.
(see Section 6)
MODULE TEMPERATURE
Number of times the inverter has stopped due to excess temperature in the
module.
(see Section 6)
STOP DUE TO AUXILIARY INPUT
Number of times the inverter has stopped due to opening auxiliary input contacts.
(see Section 6)
DRY RUN
Number of times the inverter has stopped due to a lack of water in the system.
(see section 6)
- 40 -