Scheppach ACS3000 Original Bedienungsanleitung Seite 35

• Do not overreach or stand on an unstable support.
Keep effective footing and balance at all times.
• Stay alert and watch what you are doing.
• Do not operate the unit when fatigued or under the
influence of drugs or alcohol.
• Do not kink or over-bend the hose.
• Do not expose the hose to temperatures or to pres-
sures in excess of those specified by the manufac-
turer.
• Do not use the hose as a strength member to pull or
lift the equipment.
• The maximum rated pressure of the air hose is
228bar, the normal working pressure is 207bar.
• Be aware of any hazards presented by the material
being sprayed and consult the markings on the con-
tainer or information supplied by the manufacturer of
the material to be sprayed, including requirements
for the use of personal protective equipment.
• Do not spray any material where the hazard is not
known.
• Equipment surfaces can become very hot during
operation. To avoid severe burns, do not touch hot
equipment. Wait until equipment has cooled down
completely.
• Pressurized equipment can start without warning.
Before checking, moving, or servicing equipment,
follow the Pressure Relief Procedure in this manual.
Disconnect the mains power plug!
• Read warnings to know the specific hazards of the
fluids you are using.
• Store hazardous fluid in approved containers, and
dispose according to applicable guidelines.
m WARNING - Equipment misuse hazard
• Do not use electrostatic atomizing and spraying
equipment. These can lead to a serious hazards to
the operator.
• Do not exceed the maximum working pressure or
temperature rating of the lowest rated system com-
ponent. Read Technical Data in all equipment man-
uals.
• Use fluids and solvents that are compatible with
equipment wetted parts.
• Read fluid and solvent manufacturer's warnings. For
complete information about your material, request
material safety data sheet (MSDS) from distributor
or retailer.
• Check equipment daily. Repair or replace worn or
damaged parts immediately with manufactory re-
placement parts only.
• Do not alter or modify equipment.
• Use equipment only for its intended purpose. Call
your distributor for information.
• Route hoses and cables away from traffic areas,
sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull
equipment.
• Comply with all applicable safety regulations.
• Keep children and animals away from work area.
• Do not operate the equipment when fatigued or un-
der the influence of drugs or alcohol.
7. Remaining Risks
Additional residual risks may arise when using the tool
which may not be included in the enclosed safety warn-
ings. These risks can arise from misuse, prolonged use
etc.
Even with the application of the relevant safety regula-
tions and the implementation of safety devices, certain
residual risks cannot be avoided.
These include:
• Injuries caused by touching any rotating/moving
parts.
• Injuries caused when changing any parts, blades or
accessories.
• Injuries caused by prolonged use of a tool. When
using any tool for prolonged periods ensure you take
regular breaks.
• Impairment of hearing.
• Health hazards caused by breathing in paint when
using your tool.
8. Material and paint selection
m ATTENTION! Do not use textured wall paints or
coatings as this will block the spray gun tip and
damage internal components of the airless spray
station.
8.1 Material and paints which can be used
Although a large number of materials and paints can
be sprayed, some cannot. Please check with the man-
ufacturers' recommendations.
The following materials and paints can be used:
• Water based paints
• Wood preservatives
• Oil based paints
• Primers
• Enamel paint
• Wash primer
www.scheppach.com GB | 35