TROUBLESHOOT ING
to carry out repair work.
* The connecting cord plugs are incorrectly
attached to the jacks or connected to the
wrong jacks.
© The jacks or plugs are dirty.
* The SPEAKERS button is OFF.
* The connector bars of the PRE OUT jacks or
POWER AMP IN jacks are disconnected.
* Check the connections.
* Clean the jacks and plugs.
* Set the SPEAKER button to the ON position.
* Connect the connector bars when not in use.
in cases other than Tape 2
* The TAPE 2 MONITOR is ON.
* The input selector button setting is not
appropriate for the source selected.
* There is a mistake in the operation of another
component.
* Set the button to OFF.
« Change the button correctly.
* Refer to the instruction manuals of other
components being employed.
_|
In the case of Tape 2
*® The TAPE 2 MONITOR is set to OFF.
* Incorrect operation of the cassette deck.
* Set the button to ON.
* Refer to the cassette deck instruction manual.
No picture
Sound from only one speaker,
Recording on tape is impossible
* The connecting cord is not firmly plugged in to
the jacks, or it is attached to the wrong jacks.
© The jacks or plugs are dirty.
* The input selector button is not appropriate for
the component playing.
* Other components are not being operated
correctly,
* The connecting cord or speaker cord is loose.
* The balance adjustment is incorrect.
© Incorrect operation of the cassette deck.
* Check the connections.
* Clean the jacks and plugs.
* Change the button correctly.
Refer to the instruction manuals of other
components being employed.
* Check the connections.
© Press the left and right balance buttons at the
same time to reach the center position:
* Refer to the cassette deck instruction manual.
Copying of tapes is impossible
* Incorrect operation of the cassette deck.
* Refer to the cassette deck instruction manual.
There is no surround sound
* The surround button is OFF,
© The input sound is mono but the mode is
STADIUM or DOLBY SURROUND.
* The DIRECT button is ON.
* Select the surround mode with the SURROUND
button.
* Switch ON the SIMULATED SURROUND.
# Set the DIRECT button to the OFF position.
(Surround reproduction is not possible when the
DIRECT button is ON.)
The remote control unit does
not work,
{Other components cannot be
operated.)
* There are no batteries in the remote control unit.
* The remote control sensor is not receiving any
signals.
* The remote control unit is not transmitting any
signals.
* The battery compartment cover is not perfectly
closed.
* The remote control cord is not connected.
* A fluorescent light is shining on the remote
sensor window.
* Load the remote control unit with batteries
(see page 48).
© Operate the remote contro! unit within a range
of 7 meters an angle of 30 degrees {refer to
page 48).
* Press the remote control RESET button.
¢ Check that the battery compartment cover is
closed correctly.
* Connect correctly (see page 36).
* Move so fluorescent light does not shine directly
on amplifier front panel remote sensor window.
© If the indicator does not light when the power is on, or nothing
happens when any operation switch is pressed, remove the plug from
the power outlet, Wait about 10 seconds and insert the plug into the
power outlet again and check
72
<ARE1202>
En
whether the power is on.