Werbung
TROUBLESHOOTING
SS
a
ee
e
CXsystem is turned ON for disc which has no
Cas mark.
e Audio output level of TV is too high.
e
Set the ATTENUATOR SWITCH to ON.
An analog audio disc with PAL system is
played.
(No sound is output with analog audio discs.)
9. No
sound
output
during
playback.
Even if the disc is an active play disc, there may
be some cases in which a fully still image cannot
be obtained, but this does not mean that the
player or the disc is defective.
10. During STILL playback, a part
of the screen image shakes.
Press DISP to check if chapter number
is
displayed.
11. CHAPTER
SKIP, CHAPTER
PROGRAM
PLAY
and
CHAPTER NUMBER SEARCH
cannot be performed.
Discin which no chapternumbers are recorded
is loaded.
Press CLEAR and picture will appear.
(At this point, a slightly different scene from that
which has been searched for may appear.)
It takes time to read the recorded code,
depending on the disc.
12. Certain discs take too long to
search or are not searched.
Press
or @/ and stop the playback. Press the
> or »/H and start the playback again. (Repeat
this operation a few times.)
13. Certain discs take too long to
Start or do not start.
There are errors when the disc code is read
(There is no damage to the unit).
Same as item 12 above.
14. The player takes too long to
(The repeat mode is cancelled).
find
point
A during
A-B
(INTERVAL)
REPEAT
operation.
Same as item 12 above.
Disc in which time number is recorded in minutes
"minutes"
15. Picture other than instructed
is searched in TIME NUMBER
SEARCH mode.
"minutes"
"seconds"
77
<VRE1030>
En
Werbung
