Werbung
TROUBLESHOOTING
Incorrect operations are often for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component.
Inspect the other components and electrical
appliances
being used.
If the trouble cannot
be rectified even
after execising the checks
listed below,
ask your nearest
PIONEER authorized service center or your dealer to carry out repair work.
SYMPTOM
CAUSE
REMEDY
1. Disc table is not ejected when | @
Power cord is not properly plugged into AC wall}
@
Plug in power cord.
A is pressed.
socket.
Power switch is not turned on.
e@ Turn on power switch.
Clean disc.
e
Set the disc properly.
e
Remove disc and let player stand for 1 to
2 hours until tt is dry.
e
Try to alleviate the warp.
(Refer to
Symptom 7, remedy column.)
Disc is dirty.
e
The disc is not properly set on the disc table.
Moisture has condensed on parts in the player.
. Disc table comes out.
Disc is warped.
Aim
the
remote
control
unit at the
The CONTROL
IN terminal on the rear panel is
projection monitor or AV amplifier.
connected to pioneer projection monitor or AV
amplifier.
e
Batteries are weak.
e
There is an obstacle between the player and the
remote control unit.
e
Remote control unit is not in a good location for
transmission.
. Remote control does not work.
e
Replace batteries.
e@ Remove the obstacle or shift the remote
control position.
e
Operate the remote control unit in front
of the player.
Move the TV andthe player further apart,
or cover the remote sensor of the TV
during disc playback.
Some TV sets have remote control functions that
operate improperly in response to the remote control
unit of the player.
. Operation of the remote control
unit causes the TV to operate
improperly.
WHEN A LASERVISION DISC !S BEING PLAYED
SYMPTOM
CAUSE
REMEDY
5. Disc is rotating but there is no | @ The
TV set is not turned on.
e Turnon TV.
picture.
e
Wrong connections from player to TV.
e
Make correct connections.
6. Picture
continuously
moves
| @
TheTVverticalhold controlis not adjusted properly.
| @
Adjust vertical-hold control on TV.
vertically.
e@ The playing surface of the disc is dirty.
e
Use a soft cloth and lightly wipe off the
dirt from
the surface
of the disc. If
necessary, moisten a cloth with diluted
neutral detergent to remove heavy dirt or
fingerprints.
e
LD discs only
Put the disc into the protective envelope,
then
place
it on
a flat desk
top.
Subsequently, place a flat board on the
disc, and load it with about 4 ~ 5 kgs. If it
is leftin this state for one day, sometimes
the warp will be alleviated.
7. Particular disc does not playback
properly. The playback stops in
the middle of the disc program.
e@ The disc is warped.
Heavy books
about 4 ~ 5 kgs
Flat board
Protective
Flat board
envelope
76
<VRE1030>
En
alge
Werbung
