The vehicle does not move
The drive battery is empty; the undervoltage detection powers off the motor to protect the drive battery from deep
discharge (when battery voltage is <=6.0 V).
The receiver or speed controller does not recognise a valid radio signal. The vehicle is too far from the transmitter,
the batteries/rechargeable batteries in the transmitter are empty, or the transmitter is off.
The speed controller is too hot; the overtemperature protection has been triggered. Allow the speed controller to
cool down.
The vehicle moves in the opposite direction to the throttle lever on the remote control
Use the "TH.REV" switch (fig. 1, no. 8) on the transmitter to activate the drive function reversal, as described in
section 12.9.
The vehicle moves in the opposite direction to the rotary control on the transmitter
Use the "ST.REV" switch (fig. 1, no. 12) on the transmitter to activate the steering function reversal, as described
in section 12.7.
The steering deflection is too small
Use the "ST.RATE" knob (fig. 1, no. 10) to increase the dual-rate steering setting, as described in section 12.6.
Move the knob clockwise to the right.
52