Takeuchi TB175 Werkstatt-Handbuch Seite 486

TB175 Maintenance software Ver1.0, Error Code Table
Error Code Discription
Key SW starter signal and start
01
operation for a short time.
Engine oil pressure decrease
02 after
engine starts
After the engine starts,
03 Alternator
charge is defective
04 Overheating
06 Air cleaner stopped up
07 Lift over load
Glow key SW turning on for a long
10
Time
11 Ignition at time of head Glow
The upper bound of voltage of the
12
battery is abnormal
the lower bound of voltage of the
13
battery is abnormal
15 Clock initialization
16 Engine oil disconnection
17 Alternator charge disconnection Charge signal was ON, when key switch was turned on .
The upper bound of the voltage of
31 the accelerator sensor is
abnormal
The lower bound of the voltage of
32 the accelerator sensor is
abnormal
33 CAN Communication Error
Note
Key switch starter signal was entered in less than 2 seconds
interval.
PULL action of Engine Stop solenoid was repeated in short
interval.
Signal from water temperature switch
Lifting overload appeared (more than 1second) after ACC power
supply
Glow key switch had connected more than 10 seconds.
Glow had ignited more than 10 seconds.
Voltage as over 29V had been measured over 0.5 second, after ACC
power was supplied or engine was started.
Voltage as under 16V had been measured over 2 second, after ACC
power was supplied or engine was started.
Clock in the controller had been reset.
For example, It will happen when Battery have abnormal lower
voltage in
Engine oil pressure switch condition was OFF, when key switch was
turned on .
Voltage as over 4.8V had been measured over 1.5 second
Voltage as under 0.2V had been measured over 1.5 second
9