Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Laser Class
2.
The optoNCDT102x/110x/115x sensors operate with a semiconductor laser for measurements and adjustment
of the sensor.
WARNING!
Never deliberately
look into the laser
beam! Consciously
Measurement
close your eyes or
Mounting/Adjustment
turn away immedia-
tely if ever the laser
beam should hit your
The maximum optical power is ≤3 mW. Class 1/2 (I, II) lasers do not require a laser safety officer nor any addi-
eyes.
tional laser indicator. The following warning label is attached to the sensor housing:
IMPORTANT!
Comply with all regu-
lations on lasers.
Fig 2.1: Laser warning label
Page 50
Laser Class
Laser Class
1
2
During operation of the sensor the pertinent regulations acc. to EN 60825-1 on
„radiation safety of laser equipment" must be fully observed at all times.
The sensor complies with all applicable laws for the manufacturer of laser devices.
This system is classified by the Center for Devices and Radiological Health (CDRH)
as a Class I, II laser device.
Although the laser output is low looking directly into the laser beam must be avo-
ided. Due to the visible light beam eye protection is ensured by the natural blink
reflex.
The housing of the optical sensors optoNCDT102x/110x/115x may only be ope-
ned by the manufacturer. For repair and service purposes the sensors must
always be sent to the manufacturer.
Laser type, wavelength
Infrared, 900 nm
red, 650 nm, P
< 3
max
Werbung
Inhaltsverzeichnis
