Preparation; Clamp The Pipe - GF CNC 4.0 400 Betriebsanleitung

Operating instructions CNC 4.0 400/500/630 8 WELDING
8.2

Preparation

The following page appears after confirmation of welding parameters,
to remind the operator that he must remove the previously jointed pipes
from the machine to proceed.
Push the button OK to confirm.
Remove welded parts out of clamping units to avoid damages of the machine!
Don't try to move the carriage with welded components between the clamps!!
Warning
8.2.1

Clamp the pipe

If the base machine carriage is not completely open, the following
page appears:
keep button pushed until the final opening position of the
carriage is reached, then the display moves automatically to the next
page.
25