Gps - GF CNC 4.0 400 Betriebsanleitung

10 Data
68
By using the  arrows it is possible to move from one welding protocol
to the other. If status number is 0, it means that the welding was
completed successfully; if another number is displayed, it means that an
error occurred during the process: refer to the following table to check
the error code.
Error code
12
13
6
7
27
29
42
43
15
16
18
19
20
21
28
80
85
The button is given to work in case of label printer connection (see
chapter 10.4).
10.3

GPS

By pushing this button it is possible to visualize the geographical
coordinates (latitude, longitude) of the hydraulic controller position:
Operating instructions CNC 4.0 400/500/630
Description
Heating element temperature too low
Heating element temperature too high
Ambient temperature too low (under -5°C)
Ambient temperature too high (over 50°C)
Time t3 over the limit
Time t4 over the limit
Power interruption during the last welding
Welding interrupted with stop button
Pressure P1 too low
Pressure P1 too high
Pressure P2 too high
Pressure P5 too low
Pressure P5 too high
Pressure P6 too low
Pressure P6 too high
Pipe slipped during cooling time
Carriage opened during heating time