Operating instructions CNC 4.0 400/500/630
9 Machine Set-up
9.5.3
Traceability
By selecting 'YES' in this menu, you activate this function into the
welding process, to make possible to input the pipe/fittings traceability
data, the pipe length and the installation depth.
The symbol * is displayed near to the selected option.
The symbol * is displayed near to TRACEABILITY button in the
CONFIGURATION page if the selection is YES.
The request to insert the traceability data appears after the
confirmation of the welding parameters (chapter 8.1.4).
First the operator is asked for data input about pipe/fitting at left side.
Complementary information as pipes length or installation depth must
be inserted manually, by pushing the button Input LENGTH/DEPTH; then
the following page appears:
57