GF CNC 4.0 400 Betriebsanleitung Seite 67

Operating instructions CNC 4.0 400/500/630
Attention
Attention
Once the code has been scanned, the display moves automatically to
next step.
If VOLUNTARY mode is selected, the button ► is also displayed to make
possible to skip this page without inserting any code.
By pushing the button MANUAL INPUT, it is possible to manually type the
operator numerical code:
Use the touch keyboard for data input, then confirm it by pressing the
Enter button. To switch the line use the up and down arrow buttons.
Press ► button to proceed; if VOLUNTARY mode is selected, it is possible
to skip this page without entering any code.
Press ◄ button to get back SCAN OPERATOR BARCODE page.
If the inserted barcode expiry date has passed, the error message
BADGE EXPIRED is shown. If the CHECKSUM digit of the inserted
barcode doesn't match the other digits, the relevant message is shown.
Data can be changed by reading another operator badge.
If the inserted barcode doesn't comply with standard ISO 12176-4, the
following error message will be displayed:
Then it is necessary to switch off the machine and restart.
9 Machine Set-up
61