9 Machine Set-up
Attention
56
The symbol * is displayed near to CTC button in the CONFIGURATION
page if the selection is YES. The message CTC will be also displayed in
the welding cycle diagram (see chapter 8.1.4).
Moreover, DVS-CTC will be displayed as selected welding standard in
the relevant page (see chapter 8.1.1).
DVS-CTC is not an officially acknowledged welding standard. The overall
responsibility will stay with the installer as machine owner (maintenance,
operator training, etc.) as well as responsible person for the installed
piping system (weld inspection, acceptance tests, pressure test,
compliance with installation guidelines etc.).
Operating instructions CNC 4.0 400/500/630