Second Welding Number; Fusion Preparation And Aligner Check - GF MSA 4.0 Bedienungsanleitung

Fusion process
2.7

Second Welding Number

If SECOND WELDING NUMBER function is activated, the display shows a message which
requires the insertion of a welding number in addition to the incremental one normally
recorded.
The second fusion number consist of four numerical positions and one position separated
by a minus sign.
This code is strictly related to the JOB NUMBER, it's automatically increased by one after
each fusion process if the JOB NUMBER doesn't change. Otherwise, the value is reset to
0001-A.
The operator may insert manually the digits, just pushing the () button to enter in edit
mode, and then using the ()() buttons to select the digits and the ()() to move
through the different fields. At the end the START/OK ( I ) button is used to confirm the
content. The value will be automatically incremented the next fusion if the JOB NUMBER
doesn't change.
2.8

Fusion preparation and aligner check

To use the FUSION PREPARATION function, this option has to be enabled in the
configuration menu (see 'Configuration' chapter).
If FUSION PREPARATION alert is activated, the display shows a message which requires
confirming the pipes preparation (scraping, cleaning, and alignment) has been done. If it
has been executed, press START/OK ( I ) to proceed.
If ALIGNER CHECK alert is activated, the display shows a message which requires to declare
if the aligner is properly used and installed. By pressing the UP/DOWN buttons the user can
switch between YES/NO, as soon as the selection has done, press the START/OK ( I ) to
proceed.
The preparation of the pipes according to guidelines (scraping, cleaning, and alignment) are
essential to ensure the quality of the welding.
2ND PROTOCOL NUM.
Protocol Number
11/0018-A
INSERT THE SECOND PROTOCOL NUMBER
PRESS START TO CONFIRM
PIPE ENDS PREPS?
(Peel, Clean, Align)
THE MESSAGE REMEMBER YOU TO PERFORM
PIPE SCRAPING, CLEANING, ALIGNMENT
ALIGNER
Aligner Installed?
YES
CONFIRM THE CORRECT INSTALLATION
OF THE ALIGNER
Operating manual MSA 4
22°C
09:16 11.03.14
22°C
09:16 11.03.14
22°C
09:16 11.03.14
11