7 Fusion preparation
20
7.3.2
System error
The system error could be caused by insertion of wrong welding data.
The machine block itself and you cannot continue the operation.
When a system error occurs, switch-off the machine and restart again!
If inserted welding data are correct and should problems nevertheless
arise, please contact the nearest GF service representative.
7.4
Hoist Lifting Cylinder (only CNC 4.0 630)
Press the button HOIST (available in the page SET-UP) on the display only
if CNC 4.0 630 type has been selected) to change to the next page
with buttons to open / close and to release pressure in the hydraulic
cylinder (available as optional) to lift the upper column of GF 630 hoist
unit during the assembly.
Operating instructions CNC 4.0 400/500/630