Operating instructions CNC 4.0 400/500/630
9 Machine Set-up
9.3.1
Potentiometer
Press the button POTENTIOMETER and the following page appears:
The potentiometer is the device which automatically detects the
position of the base machine carriage.
Close the carriage by pushing the button
: when carriage has
reached the final position, then push OK under the relevant button.
Now, open the carriage by pushing the button
: when carriage has
reached the final position, then push OK under the relevant button.
The potentiometer is calibrated.
Go back by pushing the button ◄.
9.3.2
Heating element
Press the button HEATING ELEMENT and the following page appears:
Set point
Measured temperature
49