GF CNC 4.0 400 Betriebsanleitung Seite 65

Operating instructions CNC 4.0 400/500/630 9 Machine Set-up
Then press button ◄ to get back to traceability data input page.
If pipe/fitting dimensions included in the barcode do not correspond to
Attention
the selected welding parameters (see chapter 8.1.4) the following error
page appears:
A specific message indicates which dimension is not corresponding,
then the operator can either push the button CHANGE SELECTED
PARAMETRS to get back to welding parameters selection for changing
the dimensions (chapters 8.1.2 – 8.1.3) according to barcode info or push
the button ◄ to get back to traceability data input to retry: in both cases
the traceability info will be reset after quitting the page.
Attention
If the CHECKSUM digit of the read barcode doesn't match the other
digits, the relevant message is also show: push the button ◄ to get back
to traceability data input to retry.
59