Clean Pipes - GF CNC 4.0 400 Betriebsanleitung

Operating instructions CNC 4.0 400/500/630
Attention
Push the button
adjust the pipes position.
If pipe ends distance is too big (not enough material to grant a proper
welding) a specific message appears:
Push the button
adjust the pipes position.
8.2.7

Clean pipes

Then you will be asked to confirm if pipes fusion surfaces have been
properly cleaned before getting the welding started.
to get back to CLAMP PIPES & ALIGNMENT page and
to get back to CLAMP PIPES & ALIGNMENT page and
8 WELDING
35