GF CNC 4.0 400 Betriebsanleitung Seite 40

8 WELDING
Attention
Advice
Attention
Attention
34
Check the pipe ends according to the following guidelines:
If pipes are properly aligned, confirm by pushing the button OK: the
carriage opens automatically and the display moves to the next page.
If not, push the button
ALIGNMENT page to adjust the pipe position and restart the complete
procedure.
To get a correct alignment of the pipes, use roller supports (at least 1
roller support per pipe)!
To stop the process immediately push the button
the CLAMP PIPES & ALIGNMENT page will appear to enable to move
the carriage!
If the pipe slides, a specific message appears.
Operating instructions CNC 4.0 400/500/630
The gap must not be larger than 0.5 mm.
Check wall offset at the same time. The wall
offset on the outside must not exceed 10% of the
wall thickness. If it is larger, the wall offset can be
reduced by adjusting the clamping unit or by
changing the clamping
clamping screws.
to get back to the CLAMP PIPES &
force using the
. After this action