Drag Pressure - GF CNC 4.0 400 Betriebsanleitung

8 WELDING
Attention
Attention
Attention
28
The minimum reference pressure is 30 bar: please tight the clamps
properly.
To stop the process immediately push the button
the CLAMP PIPES & ALIGNMENT page will appear to enable to move the
carriage!
If the pipes are not clamped correctly (less space to insert the facer or
not enough pipe material to grant welding) a specific message appears to
indicate how to adjust the pipes position.
Push the button
adjust the pipes position.
8.2.4

Drag pressure

The Drag pressure is the pressure used for moving the carriage with the
clamped components. This pressure will be calculated and added
automatically to the fusion pressure by the system.
Operating instructions CNC 4.0 400/500/630
to get back to CLAMP PIPES & ALIGNMENT page and
. After this action