Insert The Heating Element; Fusion Process - GF CNC 4.0 400 Betriebsanleitung

8 WELDING
Attention
36
Push the relevant button to save this information in the welding protocol:
independently of the answer, the display changes automatically to the
next page.
8.2.8

Insert the heating element

The heater plate temperature is set by the controller according to the
selected welding standard.
Please, consider that during the fusion process all the relevant
parameters – Temperature of the heating plate (T), Pressure (P), Time(t) –
are displayed as follows:
Set value / actual value measured by the system
Go to chapter 8.3 to proceed with the fusion process.
If the heater plate temperature is out of the working range, either the
message "Temperature low!" or "Temperature high!" is displayed and
therefore it is not possible to proceed! Wait until the heater reaches the
right temperature and the message disappears!
8.3

Fusion process

Insert the heater plate in the working position into the machine and
then push the button
display moves to the next page and the carriage starts to close
automatically.
The PTFE coating of the heating element must be protected from
mechanical damages and/or dirt.
Replace the heating element if the PTFE coating is damaged. Non-
observance will reduce the quality of the fusion joint.
Operating instructions CNC 4.0 400/500/630
to confirm and get the process started: the