GF CNC 4.0 400 Betriebsanleitung Seite 84

12 Error/Warning messages
Message
Badge expired!
BARCODE ERROR
SWITCH OFF
AND RESTART
Checksum!
DIAMETER
MISMATCH!
SDR MISMATCH!
78
Display page
SCAN Operator
OPERATOR
BARCODE
/
If MANDATORY
OPERATOR
mode it's not
BARCODE
possible to get
MANUAL
INPUT
process step.
Dedicated The operator
page.
correspond to
ISO 12176-3;
SCAN The control
OPERATOR character of
BARCODE the barcode
/
correspond to
OPERATOR
the other digits
BARCODE
according to
MANUAL
ISO 12176-3,
INPUT
/
TRACEABILITY
DATA ERROR
TRACEABILITY The data read
DATA ERROR in the pipe /
fitting bar code
correspond to
the selected
diameter or
Operating instructions CNC 4.0 400/500/630
Meaning Possible causes
badge is
expired!
the next
barcode
doesn't
Barcode is wrong
or barcode
reader has not
doesn't been properly
pointed at
barcode symbol.
12176-4.
1) Selected
welding
parameters
don't are wrong
2) Pipe / fitting
barcode is
SDR.
wrong or
barcode
reader has not
been properly
pointed at
barcode
symbol
Actions
Scan a valid
operator barcode
according to ISO
12176-3
Switch off the
machine and
restart: scan an
operator barcode
according to ISO
12176-3
Check the barcode
and re-input it.
1) Push CHANGE
SELECTED
PARAMETERS to
re-select the
diameter / SDR
or push ◄ to
reset data and
quit.
2) Check the bar
code and then
push the ◄
button to
proceed again
with scanning.