10 Data
Attention
66
Use the touch keyboard for data input, then confirm it by pressing the
Enter button. To switch between the lines use the up and down arrows.
Push buttons ◄ ► to move to the previous/next page.
OPTIONAL DATA remain stored in the memory, even if the unit is
switched off: if for the next weld the data is no more valid either erase
manually the data in this menu or push the button NO when specifically
asked at the end of the welding process (see chapter 8.3.7)!
10.2
Memory
The Memory menu includes functions concerning the fusion protocols
recording and transfer to an external database.
10.2.1
Protocols transfer
To transfer the recorded fusion protocols from the internal memory, plug
the USB stick, check the USB memory status (see chapter 10.2.2) and
push the button
disappears, then it is possible to remove the USB stick for further transfer
to an external PC (see chapter 12).
Operating instructions CNC 4.0 400/500/630
: wait until the message "Transferring..."