Connection To The Power Supply - GF CNC 4.0 400 Betriebsanleitung

Operating instructions CNC 4.0 400/500/630 7 Fusion preparation
7.2.1

Connection to the power supply

Danger of electric shock!
Check the electrical cords and devices!
Do not connect damaged cords or devices to the power supply.
Danger
Connect all devices when the hydraulic unit is switched off to avoid any
Attention
damage!
1. Connect the planer and the heating element to the hydraulic unit.
Check the symbols on the connectors.
2. Connect the potentiometer to the hydraulic unit.
Potentiometer
3. Connect the hydraulic unit to the power outlet or power generator.
Caution Check the voltage!
The generator has to be started before connecting the consumers and
must supply a constant output voltage!
4. Switch on the hydraulic unit
At machine start the following page is shown for a few seconds:
It reports the general information, including the serial number and the ID
of the hydraulic unit, the Bluetooth device ID, the installed software
versions (SW) for PLC / touchscreen and the last date for periodic
maintenance (REV.DATE - see chap.9.4.5).
17