Password Management - GF CNC 4.0 400 Betriebsanleitung

Operating instructions CNC 4.0 400/500/630 9 Machine Set-up
If VOLUNTARY mode is selected, the button ► is also displayed to make
possible to skip this page without inserting any code.
By pushing the button MANUAL INPUT, it is possible to manually type the
alpha-numerical job code:
Use the touch keyboard for data input, then confirm it by pressing the
Enter button. To switch the line use the up and down arrow buttons.
Press ► button to proceed; if VOLUNTARY mode is selected, it is possible
to skip this page without entering any code.
Press ◄ button to get back SCAN JOB BARCODE page.
9.5.6

Password management

The SETTINGS menu is protected by password (6 numerical digits):
Machine is delivered with the default password 123456.
Attention
To change the password push the button , then the following
page appears:
63