Touch Screen Interface; Settings Of Touch Screen - GF CNC 4.0 400 Betriebsanleitung

Operating instructions CNC 4.0 400/500/630
Warning
7.3

Touch screen interface

The touch screen is the operator interface of the machine, mounted on
hydraulic unit case.
Don`t place any objects on the screen!
Keep liquids away from the touch screen!
Use your finger or a soft pin to touch the screen!
Some common rules in the use:
 The button
PAGE
 The button
 The button
 To cancel a character typed with the digital keyboard, push
to go left, push
 To move among different input fields with the digital keyboard press
the Up/Down arrows
 All data typed with the digital keyboard must be confirmed by
pushing ENTER
7.3.1

Settings of Touch Screen

in the left upper corner leads you to the HOME
leads you one page BACK
leads you to the NEXT page
to go right
1. Press the button "System", on touch
screen. On the screen the explanation on
each of the 6 buttons is shown.
2. To change the brightness press F2 / F4.
With F3 the default values are set again.
7 Fusion preparation
19