GF CNC 4.0 400 Betriebsanleitung Seite 51

Operating instructions CNC 4.0 400/500/630 8 WELDING
Attention When stored fusion protocols number gets 1000, the next recorded weld
will replace the first one stored in the internal memory(see chapter 9.4.4
"Reset Memory" in "Machine Set-up").
if you need to change the fusion number get a step back by pushing
the button ◄.
After saving the record into the memory, you will be asked if the next
weld has to be executed with the same Optional Data (see chapter
10.1): if no optional data are stored, this page does'not appear.
By choosing NO all the Optional Data will be deleted from the memory.
Afterwards you will be asked if the next weld has to be executed with
the same parameters (welding standard/material, diameter, SDR).
By choosing YES the system moves automatically to page SELECTED
PARAMETERS (se chapter XX) to skip the parameters input, if NO it re-
starts from page SELECT WELDING STANDARD (see chapter 8.1.1).
If REPEAT BEAD mode is selected (see chapter 9.5.1) and the button YES
Attention
is pressed, the system will consider the same time t1 (see chapter 8.3.1)
manually confirmed in the previous weld.
45