9 Machine Set-up
Attention
54
Press button YES to confirm or press button ◄ to exit without deleting the
data.
Before to proceed with reset operations, ensure that all data is saved to
the computer! Once the data are deleted, you cannot recover them!
9.4.5
Service
The access to Service menu is protected by password and reserved to
authorized people of GF Service stations for periodical maintenance
activities.
9.5
Configuration
The Configuration menu permits to enable special functionalities and
working modes during the welding procedure.
9.5.1
Repeat Bead
By selecting 'YES' in this menu, you set the machine for working with
REPEAT BEAD mode during the equalization time t1 (see chapter 8.3.1).
Operating instructions CNC 4.0 400/500/630