Operating instructions ECOS 160/250/315
Caution
10 Maintenance
The ECOS 160/250/315 should be checked and cleaned periodically.
Normal care of the machine is limited to periodic cleaning of the outside.
Every 3200 hours of use or after 2 years the complete machine with all components
should be maintained and calibrated at a Georg Fischer certified service station.
10.1
Replacement of worn parts
PTFE coating of the heating element:
Clots, cracks or other damage:
– heating element needs to be recoated.
– send the heating element to the nearest service center or to the manufacturer.
Planer blades:
The
planer
blades
For order number see spare parts list.
Danger of injury!
Danger of cutting if the planer blades, which are sharp on both sides, are touched.
10.2
Hydraulic system
•
The hydraulic connections on the machine and on the hydraulic unit need regular
cleaning.
When not in use, the hydraulic connections on the TM base machine should be
protected with the protective caps.
10.3
Hydraulic unit
Oil level check:
Check the hydraulic oil level regularly. If necessary, refill the hydraulic oil
according to chapter 4 after.
on
the
planer
should
10 Maintenance
be
replaced
periodically.
25