Normal Mode - Micro-Epsilon Thicknesscontrol Rtp 8301.Eo Betriebsanleitung

U–Series
6. O N
UTPUT IN
Output voltage in normal mode
Voltage drop between input and
output
Ripple and noise voltage
Output current
Output power
Short-circuit current
Capacitive and inductive loads
*) This figure shows the ripple and noise voltage which is generated by the DC-UPS. The ripple and noise voltage
might be higher if the supplying source has a higher ripple and noise voltage.
Fig. 6-1 Input to output voltage drop, typ.
Input to Output
Voltage drop
0.4V
0.35
0.3
0.25
0.2
0.15
0.1
0.05
0
0 2 4 6
May. 2008 / Rev. 1.1 DS-UBC10.241-EN
All parameters are specified at an input voltage of 24V, 10A output load, 25°C ambient and after a 5 minutes run-in time
unless otherwise noted. It is assumed that the input power source can deliver a sufficient output current.
M
ORMAL ODE
nom. DC 24V
max. 0.3V
max. 0.45V
max. 20mVpp
nom. 15A
nom. 360W
min. 17.9A
max. 21A
No limitation
8 10 12 14 16 18A
www.pulspower.com Phone +49 89 9278 0
UBC10.241, UBC10.241-N1
The output voltage follows the input voltage reduced by
the input to output voltage drop.
At 10A output current, see Fig. 6-1 for typical values
At 15A output current, see Fig. 6-1 for typical values
20Hz to 20MHz, 50Ohm *)
Continuously allowed
Continuously allowed
Load impedance 100mOhm, see Fig. 6-2 for typical values
Load impedance 100mOhm, see Fig. 6-2 for typical values
Fig. 6-2 Output voltage vs. output current in
normal mode at 24V input, typ.
Output Voltage
28V
24
20
16
12
8
4
Output Current
0
0 5 10
Germany
24V, 10A, DC-UPS
15 20 25A
4/23