Figure 47 Disassembling The Drive Wheel; Figure 48 Disassembling The Caster Wheel - Otto Bock B600 Bedienungsanleitung

n
To remove a drive wheel, loosen the 4 Allen head
screws in the middle of the wheel (Figure 47) and re-
move the wheel.
n
If the inner tube of a drive wheel needs to be replaced,
loosen all Allen head screws on the inside of the rim and
pull apart the two-piece rim.
The defective inner tube is now freely accessible and can be
replaced.
Figure 47 Disassembling the drive wheel
B600
Downloaded from www.Manualslib.com manuals search engine
To change the tyre of a caster wheel, proceed as follows:
n
To remove the caster wheel, loosen the axle screw with
a size 6 Allen key (see Figure 48, item 1) and pull out
the axle.
n
Loosen all Allen head screws (see Figure 48, item 2)
and separate the two-piece rim.
The defective inner tube is now freely accessible and can be
replaced.
Figure 48 Disassembling the caster wheel
1 Axle screw
2 Allen head screw
02/2009
Maintenance and Care
Page 163