Figure 42 Kilometre Indicator - Otto Bock B600 Bedienungsanleitung

Figure 42 Kilometre indicator
Whenever the display shows km/h or m/h in the upper left
corner, the speedometer is activated. Pressing the yellow
button lets you see the trip mileage, total mileage, digital
clock, and speed one after the other.
Setting the Trip Mileage Back to Zero
Three flashing arrows on the left side of the display indicate
the trip mileage counter. To set the value back to zero, press
the yellow button for at least 2 seconds.
B600
Downloaded from www.Manualslib.com manuals search engine
Setting the Time
If the digital clock is activated on the display, you can set the
time. Press the yellow button for at least 2 seconds. The
display will flash and alternate between 12: and 24:. Press-
ing the button again when the display shows 24: will pro-
gramme the clock to show a 24-hour display. Pressing the
button when the display shows 12: will result in a 12-hour
display.
The hours and minutes can be set next. The time digits auto-
matically advance one after the other. Press the yellow but-
ton when the desired digits are showed on the display.
Setting the Total Mileage Counter
When the total mileage counter is shown on the display, you
can switch between km/h and m/h and enter the wheel cir-
cumference. To do so, press the yellow button for at least 2
seconds and then press the button again to select between
the alternating displays (km/h and m/h). The wheel circum-
ference can be calculated on the basis of the tyre size and
can be set in the same way as the clock.
02/2009
Accessories
Page 151