Adjusting The Wheel Lock - Otto Bock Motus Bedienungsanleitung

Open the screw connection of the eccentric. Place the bubble level on the caster wheel journal
and adjust the eccenter with a screwdriver (fig. 38). Retighten all screw connection and put on
the cover caps.
The proper torque for tightening the screws is 8 Nm�
INfORMATION
6.4 Adjusting the Wheel Lock (Fig. 39)
To change the position of the rear wheels, first loosen the attachment screws of the clamping
adapters of the wheel lock and push the wheel lock forward. Then reposition the rear wheels. The
wheel lock should then be remounted such that the distance between the tires and wheel lock bolts
is max. 5 mm when the wheel lock is not activated (fig. 39; subject to technical changes).
Accident risk� The wheel locks are only effective with sufficient air pressure and proper
CAUTION
adjustment. The proper air pressure is indicated on the side wall of the tire. It should be at least
7 bar (350 kPa). To ensure sufficient braking effect, use only original rear wheels with an ap-
proved radial excursion of maximally ± 1 mm.
Make sure to firmly retighten all screws and nuts after making adjustments.
INfORMATION
Tighten the wheel lock attachment with a torque of 10 Nm.
INfORMATION
35
37
36
38
55