Figure 34 Illustration Of Pressure Points - Otto Bock B600 Bedienungsanleitung

The power wheelchair can be equipped with various Re-
caro® seat models.
To adjust the back angle of a Recaro® seat model, use the
rotary handle on the right or left side of the back rest.
A release handle is used to fold down the back rest. It is lo-
cated on the side of the back rest. By pulling the release
handle upward, the back rest can be folded down to the
front. The back rest automatically locks in place when it is
brought into its initial position. Verify that the back rest is
securely locked in place every time it has been unlocked.
The Recaro® seat can be equipped with an electric back
angle adjustment option. This function is activated using the
control unit in the "additional function" mode.
With the Recaro® LT back rest, the lateral guide in the lum-
bar section can be individually adjusted by turning the hand
wheel. Turning the wheel to the front evenly moves the two
lateral guides closer to each other. Turning the wheel to the
rear adjusts the two lateral guides away from each other.
Seat
The type X and W seats have an extendable pad at the
front. The lever used to adjust this pad is located below the
seat. Pull the lever up to shift the pad into the desired posi-
B600
Downloaded from www.Manualslib.com manuals search engine
tion. The pad locks into place as soon as the adjustment le-
ver is released. The adjustment lever must audibly lock in
place and return to its initial position.
Headrest
The headrest is adjustable in both height and angle.
A second person is needed to remove the headrest. The
pressure points must be detected under the cover by feel
and pressed simultaneously (Figure 34). Now the second
person can pull the headrest up and out.
Figure 34 Illustration of pressure points
02/2009
Accessories
10
10
180
Page 145