Otto Bock B600 Bedienungsanleitung Seite 107

NOTICE
Damage due to improper use of the lift seat function
(optional). The lift seat function may only be used on hori-
zontal surfaces and only with a vertical back angle.
The seat function actuators are not intended for continu-
ous use, but only for short-term limited operation (10 %
use, 90 % idle time). General recommendation: Under
maximum load, a pause of approximately 90 seconds is
required after 10 seconds of operation. The electric seat
functions are considered independently of the driving func-
tion for this purpose.
The lift seat may only be subjected to a maximum load of
100 kg. It is possible to have the B600 retrofitted for a
maximum load capacity of 180 kg.
The lift seat may not be operated in case of errors or mal-
functions.
If creep speed is not activated when the lift seat is oper-
ated, please visit a specialist dealer immediately. The
power wheelchair may only be used with the seat in its
lowest position until the problem is corrected.
B600
Downloaded from www.Manualslib.com manuals search engine
NOTICE
Interference from electromagnetic fields. The power
wheelchair has been tested according to EMC regula-
tions. The following particularities must be observed dur-
ing operation:
The driving characteristics of the power wheelchair can
be affected by electromagnetic fields (mobile phones or
other radiating devices). Turn off all mobile devices when
operating the wheelchair.
The power wheelchair can generate electromagnetic fields
that can cause interference with other devices. Turn off
the controls whenever you do not need them.
INFORMATION
Road traffic regulations must be observed when driving on
the road.
INFORMATION
If the driving mode is changed while driving, the power
wheelchair will accelerate or decelerate.
02/2009
Safety
Page 105