Otto Bock B600 Bedienungsanleitung Seite 143

CAUTION
Risk of accidents due to a restricted field of vision.
Since the user's field of vision is restricted when the seat
is raised, extra caution is required when operating the
wheelchair with the lift seat in the raised position and when
activating the lift seat function.
CAUTION
Risk of tipping in case of additional use of the seat tilt
function. The seat tilt function must be set to the horizontal
position when driving up inclines or over curbs. Since tip-
ping resistance is reduced in such situations, additional
caution is required!
NOTICE
Risk of damage due to improper maintenance. The lift
seat must be checked for visible damage and the tight-
ness of all screw connections must be verified at least
once a month. Also maintain correct air pressure.
NOTICE
Risk of damage during transportation. Always lower the
lift seat fully for loading or transportation.
B600
Downloaded from www.Manualslib.com manuals search engine
NOTICE
Risk of damage due to overloading. The maximum load
capacity of the lift seat is 100 kg for the standard version
or 180 kg for the heavy-duty version.
INFORMATION
A sufficient supply of power must be maintained in order
to guarantee proper operation of the lift seat.
INFORMATION
The lift seat is not intended for continuous use, but only for
short-term limited operation (10 % use, 90 % idle time).
For every 1 hour of operation, the lift seat function can be
used for a maximum of 6 minutes.
The B600 can be equipped with an optional lift seat. With
the lift seat function, the seat can be raised by up to 40 cm
using a motor (Figure 30). It is controlled by the joystick in
"additional function" mode or by the push button module
(see Figure 41).
The drive function remains available even when the lift seat
is raised. As soon as the lift seat leaves the lowest position,
the speed is reduced (creep speed) because the power
wheelchair is less tip-resistant. This is indicated by a snail
02/2009
Accessories
Page 141