Figure 21 Brake Release; Figure 22 Activating The Brake - Otto Bock B600 Bedienungsanleitung

Operation
In this position, the brake still has to be engaged!
INFORMATION
If the pushing function is already active, please contact your
specialist dealer.
When the joystick is activated while the brake is
INFORMATION
deactivated, the control unit emits an error signal on the
control panel. If this is not the case, there is a malfunction
that must be corrected immediately by a specialist dealer.
Figure 21 Brake release
1 Brake release bolt
Now the brake release lever has been released and can be
pushed ahead to the stop. In this position, the control unit
Page 132
Downloaded from www.Manualslib.com
2 Brake release lever
manuals search engine
will recognise that the brake has been released and auto-
matically deactivate the driving function. As soon as the
joystick is deflected, a warning will appear on the LCD
monitor.
Once the brake release lever has been released,
INFORMATION
all braking systems are deactivated.
Activating the brake
To activate the brake, push the brake release lever up until
the brake release bolt engages (see Figure 22). To reacti-
vate the driving function, switch the wheelchair control unit
off and then back on.
Figure 22 Activating the brake
02/2009 B600