Recaro® Seat; Figure 33 Locking The Cross Bolt In The Holder - Otto Bock B600 Bedienungsanleitung

Accessories
Figure 33 Locking the cross bolt in the holder
1 Cross bolt
To put a power wheelchair with back angle adjustment into
operation:
n
Unfold the back rest.
n
Insert the cross bolt at the end of the drive unit into the
holder.
n
Lock the bolt (by pushing down the lever) so the latch
engages the bolt (Figure 33).
Page 144
Downloaded from www.Manualslib.com
1
2
2 Lock with lever
manuals search engine
Verify that the back angle adjustment bolt and
INFORMATION
lock are secure!
7.1.5 Recaro® Seat
WARNING
Risk of injury due to tipping during operation. Before
driving up slopes or over obstacles, a tilted seat must be
lowered to its basic position, the lift seat must be in its
lowest position, and the back must be in the upright posi-
tion. Slightly tilt the seat to the rear when driving down in-
clines or over obstacles and reduce the speed (max. 3
km/h).
CAUTION
Risk of tipping due to incorrect back angle adjustment.
When standing still, the back rest may be inclined to the
rear up to 30° only. During driving on level ground, the
back rest may be inclined to the rear by up to 20° only.
INFORMATION
For safe operation, please also observe the information in
Section 2.3 "General Safety Information" and Section 2.5
"Safety Requirements for Operation".
02/2009 B600