User Information; Product Description - Bosch EPS 205 Originalbetriebsanleitung

2.

User information

2.1 Important notes
Important information on copyright, liability and
warranty provisions, as well as on equipment users
and company obligations, can be found in the separate
manual "Important notes on and safety instructions for
Bosch Diesel Test Equipment". These instructions must
be carefully studied prior to start-up, connection and
operation of the EPS 205 and must always be heeded.
2.2 Safety instructions
All the pertinent safety instructions can be found in
the separate manual "Important notes on and safety
instructions for Bosch Diesel Test Equipment". These
instructions must be carefully studied prior to start-up,
connection and operation of the EPS 205 and must
always be heeded.
2.3 Electromagnetic compatibility (EMC)
EPS 205 satisfies the criteria of the European Directive
EMC 2014/30/EU.
Warning! This product may cause high-frequency
interference in residential environments so that
interference suppression may be necessary.
Robert Bosch GmbH
User information | EPS 205 | 39
3.

Product description

3.1 Intended use
The EPS 205 is used for testing nozzle-and-holder
assemblies and nozzle holders of unit injectors
(referred to in the following as DHK/UI), common
rail injectors with a solenoid valve for passenger and
commercial vehicles (referred to in the following
as CRI/CRIN) and piezo common rail injectors for
passenger vehicles (referred to in the following as CRI
Piezo). With the EPS 205 it is possible by way of an
automatic test procedure to determine whether or not a
tested component is still fit for use.
!
If Opening pressure 2 measurements on DHK/
UI reveal measurement deviations, this does not
justify warranty claims if the Opening pressure 1
measurements are OK. CRI/CRIN measurements on
the EPS 205 do not qualify for warranty entitlement.
i
The latest test procedures and set values for
the various Bosch injectors are contained on
the "TestData CD". We recommend an update
subscription (subject to charge), available from your
equipment supplier or local subsidiary.
i
Additional special accessories are required for
testing other makes of CRI, Bosch CRIN and UI
nozzle holders. The preparatory work for testing UI
nozzle holders is described in the ESI[tronic] 2.0
test and repair instructions (CD-K).
i
EPS 205 is not designed for continuous testing.
en
|
1 689 989 185 2018-03-24