Installing The Driven Sprocket; Installing The Timing Belt - Yamaha F115A Wartungshandbuch

POWR
Å
A
TIMING BELT
ı
5160
5170
5180

INSTALLING THE DRIVEN SPROCKET

Install:
• Driven sprocket bolt
Driven sprocket bolt
60 Nm (6.0 m • kgf, 43 ft • lb)
Flywheel magnet assembly
holder
YB-06139 / 90890-06522
Å For USA and Canada
ı For worldwide

INSTALLING THE TIMING BELT

CAUTION:
• Never forcefully twist, turn inside out, or
bend the timing belt.
• Do not let oil or grease get onto the tim-
ing belt.
• A Minimum 25 mm (1.0 in)
Install:
• Timing belt
• Tensioner
Installation steps
(1) Align ø6 hole on the pickup rotor with
the notch in the cylinder block.
(2) Align the marks "
sprockets with the top edge of the cyl-
inder head.
(3) Install the timing belt onto the driven
sprockets and drive sprocket.
(4) Install the tensioner.
Tensioner bolt
40 Nm (4.0 m • kgf, 29 ft • lb)
(5) Turn the crankshaft clockwise two
times and
sprocket and driven sprockets are cor-
rectly aligned with the marks.
5-13
" on the driven
make sure the
E
5
5
drive