Takeuchi TB014 Werkstatt-Handbuch Seite 385

SM-E2B SERIES, WSM
Injection Timing (Continue)
A The sealant is applied to both sides of the shim (soft metal
gasket shim). The liquid gasket is not required for
assembling.
A Shims are available in thickness of 0.20 mm (0.0079 in.),
0.25 mm (0.0098 in.) and 0.30 mm (0.0118 in.). Combine
these shims for adjustments.
A Addition or reduction of shim (0.05 mm, 0.0020 in.) delays
or advances the injection timing by approx. 0.0087 rad
(0.5 ).
A In disassembling and replacing the injection pump, be
sure to use the same number of new shims with the same
thickness.
A Refer to figure below to check the thickness of the shims.
A The injection timing might be changed by the application.
(Reference)
A Injection Timing Map (before T.D.C.)
Model
Z482-E2B
Rated Speed D662-E2B
Specification D722-E2B
( (rpm))
0.33 to 0.37 rad.
3600 to 3301
(19 to 21 )
0.31 to 0.33 rad.
3300 to 3001
(18 to 20 )
0.30 to 0.33 rad.
3000 to 2501
(17 to 19 )
0.26 to 0.33 rad.
2500 to 2001
(15 to 17 )
0.23 to 0.26 rad.
Under 2000
(13 to 15 )
S-21
DIESEL ENGINE
Z602-E2B
D782-E2B
D902-E2B
0.33 to 0.37 rad.
(19 to 21 )
0.28 to 0.31 rad. 0.30 to 0.33 rad.
(16 to 18 ) (17 to 19 )
0.28 to 0.31 rad. 0.28 to 0.31 rad.
(16 to 18 ) (16 to 18 )
0.24 to 0.28 rad. 0.24 to 0.28 rad.
(14 to 16 ) (14 to 16 )
0.23 to 0.26 rad. 0.23 to 0.26 rad.
(13 to 15 ) (13 to 15 )
0000008686E