Takeuchi TB014 Werkstatt-Handbuch Seite 447

SM-E2B SERIES, WSM
Rotor
1. Measure the resistance across the slip rings.
2. If the resistance is not the factory specification, replace it.
3. Check the continuity across the slip ring and core with an
ohmmeter.
4. If continuous, replace it.
Rotor resistance Factory spec.
Slip Ring
1. Check the slip ring for score.
2. If scored, correct with an sand paper or on a lathe.
Factory spec.
Slip ring O.D.
Allowable limit
Brush Wear
1. Check the length of the brush, if the length is shorter than the
allowable limit, replace it.
2. Make sure that the brush moves smoothly.
3. If the brush is defective, replace it
Factory spec.
Brush length
Allowable limit
S-83
DIESEL ENGINE
2.9
0000001376E
14.4 mm
0.5669 in.
14.0 mm
0.5512 in.
0000001377E
10.0 mm
0.3937 in.
1.5 mm
0.0591 in.
0000001378E